Picture this: Your clients are right in the middle of footwork on your gorgeous Allegro 2 Reformers, dutifully pressing in and out, coordinating their breath, paying attention to their spinal position, and following all your other cues. All of a sudden, the next time they bring the carriage in, instead of a soft thump when the carriage hits home, there is a loud, metallic clang.
Maybe, even, there is now a humming reverberating along the reformer rails as they move.
But luckily, it’s a simple fix.
First, some background. Earlier versions of the Allegro 2 used U-shaped rubber bumpers which attached to the carriage itself. Over time, these can come loose and either fall off, or get caught half-way off and make noise as the carriage moves up and down the rails.
If you have these U-shaped bumpers you should replace them as a preventative measure.
The new style bumpers are square and flat. Here is a great photo showing the difference between the two.
To apply the new bumpers you need to provide a clean surface to adhere them to. The place you’re looking for is a little hard to see, but if you take a light and look down inside the rail toward the footbar, you’ll see a flat, silver, rectangular surface. That’s where you’re going to stick the square bumper.
Before you stick one of those squares on there, make sure the surface is clean (especially if there was a square bumper there before.) This is one of the only times I recommend using GooGone to get rid of any lingering sticky mess. It’s totally fine to use because you are using it on a metal surface that isn’t visible to the client, but don’t make a habit of using this everywhere!
Cleaning the surface is very important! You don’t want the new bumper to fall off right away.
Finally, stick your new bumper on the clean, dry surface. Check out these two photos below. You need to stick the bumper on the side closer to the inside of the reformer, rather than the outside.
If you place the bumper too far to the outside, the edge of the carriage that comes into contact with it will only hit the edge, and that can cause it to wear and fall off really early.
Can you see the smashed side of the bumper that is pushed too far left?
You can even test the position by putting your finger on the edge of the carriage rail (the silver metal piece underneath the carriage) and gently moving the carriage toward the bumper, feeling where the edge of the carriage contacts the bumper. The carriage edge should be centered on the bumper.
Once you verify that placement, repeat the process on the other side of the Reformer (right/left).
You’re now ready for a quiet Reformer session on your Allegro 2!